![]() Small scrapes to the black part should not affect the functionality. Regarding the charging coil, you can check whether the phone wireless charges still. ![]() It's best to put everything that was in the phone back the way it was but one missing bracket screw is not the end of the world and shouldn't cause issues. The good news is that your phone is not toast and you haven't done anything irrepairable, the bad news is that you will probably need to replace your charging port again.Īs for the other issues you mentioned: the phone will function perfectly fine if you forgot one of the screws for the bracket. See this question for more information (different model, but same issue). ![]() To verify this issue you can check the panic logs (search "Analytics" in settings, look for a file called "panic-full-xxx.ips" under Analytics Data). Since you replaced the lightning port here I suspect this is the issue. If this sensor is damaged or missing (as it may be on poor quality 3rd party parts), the device will reboot itself every 2 minutes and 50 seconds if the screen is on (it won't reboot while locked). On iPhones released after the iPhone X there is a sensor on the charging port flex that communicates with the CPU. A pity since it is still quite new and worked perfectly apart from the headphones issue. I don't think any repair shops will take my phone, much less any apple-certified technicians and can't get any money for it so at this point my only solution is to toss it and get a new phone. The thing that was really tricky was to get the little coax connector of the antenna convertor cable to fit on the new lightning port assembly, but it seemed to fit just fine and wifi and 4G still works perfectly. Is there any other solutions I could try? Any specific hardware that I could trouble shoot? When replacing the lightning port assembly almost all components were removed so could be anything, but I feel like I managed to put everything back together where it should. While replacing the battery for the second time I got impatient and was too rough and probably damaged the wireless charging coil beneath the battery, but this occurred after the issue started.I lost one of the tiny 1,3 mm phillips screws to the upper bracket covering the upper front panel connector, but the bracket keeps snug with the remaining screws and I doubt this would affect anything.There are two known hardware issues that occurred during my replacements: I DFU-reset the phone in case it was a software issue but the issue prevails. Same issue, phone works perfectly but keeps restarting. I suspected a bad battery and switched back to the old apple battery. ![]() However, the phone does not seem to keep restarting if it is locked and not being used. Airplane mode or removing SIM-card tray does not resolve the issue. This happens both when connected and not connected to power and seems to happen no matter what I do with the phone. The only issue (which renders the phone unusable) is that the screen turns black and the phone restarts after using it for a few minutes. The replacements seemed to work fine and the phone and all its functions worked without a problem. ![]() My headphones kept losing connection when plugged into the lightning port (especially when the phone was in my pocket and I made certain movements like walking up stairs or cycling) and after replacing headphones twice and cleaning out the lightning port thoroughly I decided to replace the lightning port assembly, and while at it I also decided to replace the battery. Issue: Phone turns black and restarts every few minutes after replacing battery and lightning port assembly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |